TIN
TIN
Series Space Heaters
The Temprite indoor TIN unit offers complete flexibility to the engineer and owner to meet any design need. Controls can be set up for space heating, make-up air or a combination of both. The standard indirect fired space heater is a vertical floor-mounted unit. If floor space is not available, the heater can be offered in either a horizontal-suspended or inverted position.
TIN series units have nominal heating capacities from 437,500 to 7,500,000 BTUH (input) and air handling capacity from 3,500 to 94,000 CFM.
Learn More about Indirect Fired Products
Features
Literature
Take a look at our complete Literature Library for even more information
4-Pass Drum and Tube Heat Exchanger
Maximum Heat Transfer Surface Area
The Temprite TIN system 4-pass heat exchanger consists of a large primary section and a secondary section of multiple tubes depending on the capacity you require. The sections are connected via collector boxes at the ends of each pass. The primary section of the heat exchanger is manufactured of 400 series stainless steel and secondary section is manufactured of mild steel {standard} or 400 series stainless steel {optional}. The primary section is rolled, and seam welded in the Mestex factory in Dallas. All seams are continuous welded in the factory and tested for leaks. The primary section has a pressure relief and visual inspection port. The secondary section includes a condensation drain port.
DDC Controls Are Optional
Patented Precision
The TIN is capable of more precise temperature control and real time on-board diagnostics thanks to the patented TracRite DDC control system. Interfacing with local networks is made easier since the TracRite system supports BACnet, LON, N2, and Modbus.
Touch Screen Interface Option
Convenient Control and Diagnostics
In addition to the precision and sophistication of the TracRite DDC control software, Temprite has implemented a touch screen operator interface for quick access to operating conditions, diagnostics, setpoints, and schedules.
V-Bank Filters Optional
Clean Filtered Air
The Temprite TIN has the option of a V-bank filter bank for clean tempered air entering the space. The filter bank has racks that will accommodate 2" filters with up to MERV13 ratings.
Induced Draft Fan
Venting Combustion Products to the Atmosphere
A direct drive motor spins the fan in the induced draft assembly and vents the combustion products to the atmosphere. The entire assembly (less the moror itself) is manufactured in the Dallas factory. The fan is of a non-clogging, radial blade design. The assembly also includes a manual damper with locking quadrant so that it can be adjusted during the startup process to assure proper induction.
Powered Combustion Burner
Efficient Air/Fuel Mixing and Combustion
The combustion burner has an integral blower and motor, air proving switch, and pilot assembly. There is also a combustion air damper that is interlocked with the gas control valve in order to produce the proper air/fuel mixture throughout the operating range.
Factory Assembled Gas Train
Tested and Ready to Fire
The factory wired and assembled gas train consists of low pressure gas regulator, motorized gas control valve, main gas shutoff valve, pilot pressure regulator, and pilot gas shutoff valve.The burner controls can be On/Off, Hi/Low/Off, or Fully Modulating.
